You can set the minimum extrusion width to a small value (20-25%) for better fill. You could also use classic mode with gap fill.
You can use ironing for both to improve the results.
Also consider WebauthN/Passkeys. They are much less ressource intensive on the server but useless to an attacker when the database is leaked and as such don't rely on slowing down the crypto operations.
Your first step will be learning to dry it and keep it dry. I can recommend a scale that can resolve to at least 0.1g so you can measure the weight loss while drying. This will help in seeing when it's sufficiently dry (put it in dryer and weigh it every hour) and if it took moisture again.
There are so many VPN providers selling your data, being operated by the feds, operated by cybercriminals etc. it really doesn't matter just as said in 8.
It looks like there are multiple layers printed without feeding filament, which causes these frays to build up. Could it be that the filament clogs after this layer? Or do you see that filament still properly feeds later?
This could happen for example due to heat creep and the filament getting too warm/soft in the extruder to properly feed or you trying to feed too fast.
However I can see when any IPv6 begins with 2a02:12xx:: then it's Swisscom (biggest swiss ISP). But I can't remember any of their hundreds of IPv4 prefixes.
You might be able to make it much stiffer by adding more of the arms parallel. The force should be consistent when you tighten multiple of them with one screw.
If the Provider of the Service (the "Provider") needs a place to crash and you have a sofa available, you should maybe give the Provider a break and let him sleep on your couch.
If you are caught in a dire situation wherein you only have enough time to save one person out of a group, and the Provider is a member of that group, you must save the Provider.
THE ACCESS IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO BLAH BLAH BLAH ISN'T IT FUNNY HOW UPPER-CASE MAKES IT SOUND LIKE THE LICENSE IS ANGRY AND SHOUTING AT YOU.
Lower speed between the holes because of low acceleration. Because of this more heat is brought into the layer which makes it more shiny. Your nozzle doesn't reach the same speed on a 20mm line as it does on a 200mm line.
You can set the minimum extrusion width to a small value (20-25%) for better fill. You could also use classic mode with gap fill. You can use ironing for both to improve the results.