That I am aware of. But without any circulation the hot air will simply cool down and condensate once I turn off the dryer, wouldn't it? Leaving either highly saturated air or even some water droplets, ready to be absorbed by the filament again
I still don't understand how those cheap filament dryers work: they fully enclose the spool and heat up the air for a few hours. But where does the moist air go? It's still trapped in there with the filament. It makes no sense!
I always leave the filament dryer a bit open so the warm air can escape, taking the moisture to a better place (far away from the filament)
Yeah those communities are wild. Before I bought my own printer I thought 3D printing is mostly fixing your printer and buying better parts and bed leveling and tuning etc.
Wasn't looking forward to it so I bought an off-the-shelf printer with minimal assembly from a "boring" Chinese brand - couldn't be happier with it, it just prints without any hassle and I have no urge to switch firmwares or tinker with the printer itself instead of with the printed stuff. To each their own I guess.
(Still plugged in a raspberry pi for octoprint and did some initial calibration for the filament of course ...)
I'm in the same boat: Hollow Knight frustrated me so much that I never finished it, even though I really liked the lore and the world and the non-boss fights.
Celeste on the other hand might be even "harder", but as you respawn on every screen literally instantly, you can fail and retry hard parts a hundred times until you make it.
Pretty much the beginning of Manna, a short story that is over 20 years old but seems to be more relevant than ever (or at least a good 1-2 hours read). [edit: typo]
To me it seems pretty clear: withholding means you don't get your mail delivered and cannot fetch it yourself at the post office, while "not delivering" means just that: you don't get your mail delivered.
There's a lot of open source browsers out there.
Would you use one if it doesn't have [...] mandatory extensions?
There are literally only chromium-based browsers and Firefox (and its forks) with any meaningful market share. Developing a new browser engine is extremely complicated and time consuming, so there really is no danger of having "too many" browsers. And of course all browsers based on chromium (Google Chrome, Edge, Vivaldi, Brave, ...) support the same set of extensions, because they use the same engine. So extension compatibility is also not a problem.
Supporting the gazillion ever-changing web technologies and standards and layout systems for a completly new browser is a problem though.
Honestly I would probably not use it. One if the most important things I'm looking for in an API is reliability - and a project that has no financing is really just waiting to have its plug pulled.
You might be highly motivated right now to keep it going for many years. But without a steady income it might just be a burden to keep it going at some point.
(Nothing personally obviously, I don't know you and wish you all the best!)
That I am aware of. But without any circulation the hot air will simply cool down and condensate once I turn off the dryer, wouldn't it? Leaving either highly saturated air or even some water droplets, ready to be absorbed by the filament again