In defense of this, I work on a service that uses square and allows tips. One of the issues with square tips is you can only ask for percentages, not dollar amounts. Since the service I work on usually costs $1-2, we have to put in high percentages for tips in order for it to be meaningful. I believe ours is set to 25, 50, 75 and 100%. Which is usually equivalent to <$2. They could have had a similar situation here except whatever service they offer ended up being far higher than normal.
I am curious how 3 dots in the status bar are a “large problem” for you. Seems weird. If it’s getting in the way of your control panel or notifications, swipe further to the side.
I had an ender 3 as well. Every time I used it I had to calibrate and level it, and watch the the print for the first few layers to make sure it was going to work. I’d estimate it had failed prints around 50% of the time. Eventually it died and I got a anycubic kobra printer. It is so much better it’s unbelievable. I leveled it once when I first assembled it. Since then I haven’t calibrated it or leveled the bed once. I’ve done over 100 prints on it with a 0% failure rate. It is truly a printer where I can tell it to print something and come back 10 hours later and have a perfect print.
At the time, I was looking for a way to make movie theater tasting popcorn at home. The microwave ones that claim to taste like it are terrible. I saw this, tried it and it is amazing. I make it for everyone I know and they all agree that it’s the best homemade popcorn they’ve ever had. Ghee is the way to go!
Hot tub chemical stores always tell you to use bromine instead of chlorine. They claim chlorine will destroy your tub. I have been using chlorine for 20+ years on 3 different tubs. Never had a problem. I suspect they recommend bromine only because it’s more expensive.
Excellent post. If I’m ever in this situation, I will come back to this.