muusemuuse @ muusemuuse @lemm.ee

Posts

11

Comments

383

Joined

4 mo. ago

I wanted to build my own module that would let me query and inject codes into my cars CAN bus and replace onstar with that. Short version of this is that GM says no, you cant use the car in a way that doesnt generate profit for us.

honestly, the nazis always had the right idea, just the wrong targets. They should have put themselves in the damn gas chambers.

Really? Tell me how Brexit happened then.

it's that i escape but yes

I’m a US citizen looking for a way out and it’s probably not going to happen because I’m not rich and I’m not important.

The good news is I will likely be killed over this horseshit soon enough so I won’t have to suffer that long with it.

cloud is ridiculous. just set up some mini servers with friends or family. rsync your stuff with them over wireguard every now and then. The cloud should absolutely never ever be trusted.

I2p has a git service

the spool says not to exceed 250

I actually lowered it to 250 and turned off the fan and it didn’t help.

beacon hovers over the bed. it doesnt touch anything.

I looked at your guide and theres something interesting mentioned for my model, the trident. the actual temp is lower that the measured temp on the top of the bed due to the thickness of the bed! I shoudl raise it by 10 degrees. I'm going to try that in a bit

I notice my open air bambu labs p1p doest have any problems like this and it doesnt need a heat soak. Isnt the voron a better machine with higher quality parts?

its a 25 minute heat soak before each and every print. I wonder if I should break that out of the print start macro and make its own macro.

its a magnetic sheet so that shouldn't throw anything off. I flipped to the smooth side of the sheet which is much takier but its still having the same issues.

Look unless you are holding out on a bag of unused monkey paws this is all we have to work with.

I am constantly manually tweaking Z offset at the start of prints so here's hoping the heatsoak solves that.

I have reworked the start_print gcode macro to incorporate a heat soak before scanning for a mesh. While its running that 20 minute soak, I notice that the temperature reading on the beacon coil is actual dropping while everything else is increasing during the soak. Is just above the bed, in the center, doors closed, and its readings are getting steadily lower. What could possibly cause that?

EDIT: Here's where I ended up with my printer.cfg file for my 300 mm^3 voron trident. Do you see anything suspicious? https://pastebin.com/AxxEypK4

I'm actually looking into this now with some hubspace lights I have. They seem to have disabled flashing from the bootloader so the only way to do this is with signed updates from the manufacturer. But I dont like the cloud-only method of control hubspace uses so it looks like.....desoldering the original ESP32 and putting on another one thats been flashed with ravencore, ESPhome, WLED, or tasmota is what I'll have to do.

I noticed something while printing. it doesnt have a bed mesh loaded when it prints. it saves the last mesh, but doesnt load it. why?

cranked up the mesh points and switched from lagrange mesh to bicubic. here we are at 35x25 points. weird, I see spikes.

Oh and to answer your question, there is one linear rail on the X axis.

Where could that twist be?