Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)WE
Posts
36
Comments
715
Joined
2 yr. ago

  • I've read manual for my new 3D printer but it was in a foreign language so I had to cook up a way to understand it, luckily I travel a lot so learning languages is not that difficult for me. I hope that this writing paints good enough of a picture on how it went. I forged up some way to accelerate my learning process so that I could get trough it swift like an arrow. There certainly were some steep inclines which I had to overcome but in the end it all went swimmingly. The only issue was that I could not muster any courage to approach my crush. I just stood there like a stump and stared at her eyes that glistened like stars. In the end it turned out she was a hoe so I dodged a bullet.

  • FreeCAD is great but has some certain limitations you may run into with more complicated projects.

    Onshape is amazing given you can use it for free but... It has other types of limitations regarding ownership and licencing (for free version).

  • I'm at the point where I still miss some Windows functionality but at the same time I've been on Linux for half a year now and can say with absolute certainty that there are now things that I would miss from Linux if I switched back to Windows.

    So both OS can now irritate me equally in different ways.

  • When you try to run a thing that everyone assures you now works on Linux flawlessly but for some reason it does not work for you in particular so you dwell deep into troubleshooting and try everything possible until you break something but then you figure out how to make it work without breaking your system so you re-install OS and start again for it to just suddenly work without the workaround just so you stumble on the same scenario with another program.